deformation
deformation
1. USB plug slant : Reject if USB plug inset or pull cause slant or deformation.
5 USB端頭歪斜:因插拔不當造成板端公頭歪斜變形者不允收.
2. The deformation D4 resulted from Caledonian movement.
D_4期变形为后期加里东运动的产物。
3. ECAP is an effective method realizing pure shear deformation.
ECAP是实现材料纯剪切变形的有效方法。
4. There is no materials but will deform more or less under the action of forces.
一切材料在力的作用下多少会变形。
5. In general, the deformation of the model grille is a combination of axial and shear strains.
一般情况下，模型栅格的变形是轴向应变和切向应变的组合。
6. Do not bend or deform the probes as this could cause irreparable damage.
不能弯曲或毁坏探头的表面，因为这将导致不可修复的损坏。
7. At last, the solution of the formula for different deformation amplitude is explored.
与现有方法相比，该方法能够更加准确地描述金属橡胶的非线性迟滞特性。
8. In severe cases, it can deform joints and cripple its victims.
严重的病例，可使关节变形，使病人残废。
9. Severe variations deform the discharge curves.
严重者使放电曲线发生畸变。
10. It provides a scientific evidence for study on the plastic deformation of ledeburite steel and iron materials.
为莱氏体钢铁材料塑性变形的研究提供了科学的证据。
11. It is seen that the deformation parameters agree rather well with each other.
人们看到形变参量彼此符合得相当好。
12. With toe (HSI) A slow growth, thickening deformation, dry skin thinning, Ganmao exfoliated and muscular atrophy.
伴趾(指)甲生长缓慢，增厚变形，皮肤干燥变薄，汗毛脱落和肌肉萎缩。
13. Plastic deformation as the result of dislocation motion; also, the shear displacement of two adjacent planes of atoms.
位错移动导致的塑性变形或两个相邻原子面的剪切位移。
14. Pore deformation of low-permeability gas reservoirs is characteristic of elastic plastic deformation.
低渗透气藏孔隙变形具有弹塑性变形的特征。
15. Not only deformation was controlled, but also cost and engineering time were reduced.
作为大面积、深开挖的基坑工程既控制基坑变形又达到降低工程造价、缩短工期的目的。
16. To subject to mechanical force or pressure to the point of deformation.
使受压力过度因承受机械力或压强而达到了变形的程度
17. The same LM algorithm is used to track the affine deformation parameters of the target.
使用LM优化方法跟踪目标的仿射运动参数。
18. Service life is long, not changeful deformation is lubricious.
使用寿命长，不易变形变色。
19. The other 31, kitchen cabinet counter any body deformation?
其他31、厨柜柜身有无变形?
20. The deformation frequencies are not sufficiently distinctive.
其变形频率不是十分明显的。
21. The hot deformation activation energy of KFC copper alloy during hot deformation is 288.79 kJ/mol.
其热变形激活能Q为288.79kJ/mol;
22. The result can be employed in motor case assessment and reliability design based on plastic deformation.
其结果可供基于塑性形变的壳体评估及可靠性设计参考。
23. Of specific interest are deformation (strain) which occurs when a stress is applied, hardness and toughness.
具体说就是施加一个应力时而产生的变(应变),硬度,韧性。
24. Not deformation, impact resistance and other properties.
具有不变形、耐冲击等特性。
25. Ice crystals begin to deform measurably.
冰晶就产生某种程度的变形了。
26. The study on the mechanical deformation mechanism of the ice and the ice/structure interactions is an important topic.
冰的力学变形机理以及它与结构相互作用力问题的研究是力学领域内研究的重要课题。
27. Geometry processing, deformation etc. in advance of rendering on RSX.
几何运算、变形等等这些部分则会利用到RSX的渲染优势。
28. The first reason is the loose rock? soil constitution and deformation of fossil landslide.
分析表明,古滑体复活的首要原因是古滑体的变形破坏及其疏松物质组成为滑体复活创造了基础。
29. The initial stress or deformation fields are not usually homogeneous .
初始胁强场或初始形变场通常并不是均匀的。
30. In flattening test,the crack happened in the lagest deformation parts.
压扁试验中试样的最大变形部位出现裂纹状缺陷。
31. It is found that the nuclear deformation effect can change the shape of PES significantly.
原子核的形变效应对于势能面的形状有较大的影响。
32. STUDY ON DEFORMATION PROCESS OF COLD TUBE ROLLINGWITH DOUBLE-SET THREE-ROLLER MILL?
双排多辊式钢管冷轧变形过程研究?
33. Development deformation is enamel commonly depauperate, spot glair tooth and too small tooth.
发育畸形常见的为釉质发育不全，斑釉牙及过小牙等。
34. The weakened superficial layers of cartilage develop fi ures in re o e to increased deformation by normal loads.
变弱的表层软骨因对正常负荷增加变形而发生裂隙。
35. Deformation: The object has changements of shape and dimension under some influences of outside conditions.
变形:物体在某些外界条件下的影响下,发生形状和尺寸的变化。
36. To undergo plastic deformation without cracking or breaking. Used of rocks, metals, or minerals.
变形不经压碎或打破而产生的人为损坏或变形。用于岩石、金属或矿物质
37. The deformation strength is declining eastward and seaward.
变形强度总体趋势由西而东，由陆向海减弱。
38. Large deformation only occurs in the case of very high rotation speed.
只有在转速极高时，弹道簧才会产生局部严重变形。
39. Only for values between 0. 6 and 1. 0 is the mode of deformation in doubt.
只有该值取0.6到1之间,变形的模式才是未确定的。
40. What can see more deformation is mitotic.
可以见到较多畸形的有丝分裂。
41. ASB is the damage reason in the condition of deformation at high speed rate.
可以说，绝热剪切带是材料高速率变形条件下损伤的原因。
42. Laminated adhesive to prolong the useful life, tear proof, attrition proof, deformation proof.
可通过覆盖加强塑料膜等方式延长使用寿命,防止撕裂、摩擦、变形等。
43. To mar or spoil the appearance or shape of;deform.
台湾岛的形状是一个拉长的椭圆形。
44. Pac-Frankenstein version of Pac-hand tour of the deformation!
吃豆怪人版，吃豆的变形手游！
45. Considering the elastic deformation of the barrel,the AA gun is simplified into a multi-rigid body dynamic model.
同时考虑身管弹性变形,建立了火炮发射时的多刚体动力学模型。
46. Same reason can make bow-backed deformation accentuates gradually.
同样原因可使驼背畸形逐渐加重。
47. Setout ellipse curve with the traditional method of four-center will bring up offset of point and deformation of chart.
四心圆法测设椭圆曲线会造成点位偏移,图形变形。
48. As the deformation of steels increases from 23% to 76% the processes of recovery and recrystallization are accelerated.
在其它条件给定时,经76%面缩率拉拔后的钢与23%面缩率拉拔后的钢相比,前者的回复及再结晶过程加快;
49. There is no material but will deform more or less under the action of forces .
在力的作用下，各种材料多少要产生形变。
50. There is no material but will deform more or less under the action of force.
在力的作用下，没有一种材料不或多或少地变形。
51. A spiral deformation occured in the lower part of the young leaf enclosed in the sheath.
在叶鞘裹住的幼叶下部呈现螺旋状。
52. Plastic deformation concentrates at the ferrite area under the tensile stresses.
在拉应力作用下,塑性变形集中在铁素体区.
53. In every heart period, the max deformation scope of the aorta lies descending thoracic aortic isthmus.
在每个心动周期,主动脉变形幅度最大处位于降主动脉峡部。
54. In measuring the pipeline curvature, the FBG sensor may be twisted due to sustaining bending deformation.
在测量地下管线的离散点曲率时，光纤光栅传感器除了承受弯曲变形外，还会发生扭转的情况。
55. Outside the strip zone, deformation is elastic.
在窄带区以外，变形是弹性的。
56. We shall present certain introductory notions that pertain to finite deformation in this chapter.
在这一章里，这们将初步地介绍一些关于有限变形的概念。
57. Adhesives for tiles. Determination of transverse deformation for cementitious adhesives and grouts.
地砖胶粘剂。有粘结力的胶粘剂和灌浆的横向变形的测定。
58. A steady increase of load on a part will cause it to deform gradually.
均匀增加零件的负荷会使零件逐渐变形。
59. Cracking Analysis of High Arch Dam Heel Based on Deformation Reinforcement.
基于变形加固理论的高拱坝坝踵开裂评价。
60. Matrix should be of martensite, because it can resist impact and has little deformation.
基体应是马氏体，它能抵抗冲击，变形小。
61. Plastic deformation is the ability of bend or deform before breaking.
塑性变形就是在断裂前弯曲或变形的能力。
62. Plastic deformation and creep are highly undesirable, resilience is favourable.
塑性形变和蠕变是很不利的，回弹性则是有利的。
63. Capable of undergoing continuous deformation without rupture or relaxation.
塑性的能够历经持续变形而不断裂或松弛的
64. Applied stress causes plastic deformation.
外加应力引起塑性形变。
65. Deformation sequence of UHP rocks from the Dabie Mountains, China. Chinese Sciences Bulletin, 1995.
大别山与合肥盆地的构造耦合,科学通报,1997。
66. Natural clays have their structure which must be destroyed during the deformation process.
天然粘土一般都具有结构性，其变形过程必然伴随着结构的破坏。
67. Shoes that are too tight deform the feet.
太紧的鞋使脚变形。
68. The shale beds in between generally deform plastically.
夹在其中的页岩层通常是塑性变形。
69. She appeared to deformation of the face.
她出现了能变形的面孔。
70. Her own 12-year-old son, David, had already undergone three surgeries for a heart deformation.
她自己的12岁的儿子戴维曾经做了三次心脏变形手术。
71. How do engineering materials deform when bearing mechanical loads?
如何做工程材料变形时，轴承机械载荷?
72. If a refraction or a reflecting body is irregular, the wave front undergoes a deformation.
如果折射体或反射体是不规则的,波前即产生变形。
73. If a refraction or a reflecting body is irreqular, the wave front undergoes a deformation.
如果折射体或反射体是不规则的，波前即产生变形。
74. They are not second-order approximations, but are exact for any amount of deformation.
它们不是二次近似，而是对任何变形量都成立的精确表达式。
75. It will deform into an elongated blob.
它会变形而成为一个拉长了的滴状体。
76. It is assumed that the plastic deformation is incompressible.
它假定塑形变形是不可压缩的。
77. To each increment of load they respond with a definite change of stress and deformation.
对荷载的每个增量，应力的变形都有确定的变化。
78. Yielding strength is indicative of the stress at which plastic deformation begins.
屈服强度是指塑性形变开始发生时的应力。
79. Rockmass corrosion is the base deformation and failure of the subgrade slope.
岩体腐蚀是路基边坡变形破坏的前提与基础。
80. Rock fracture and rock flowage are different types of geological deformation.
岩石破裂和岩石流动是不同类型的地质变形。
