diffusor
1. In order to minimalize the influence of the detection system on the measurement, the light passes a depolarizing diffusor located immediately behind the analyzer.
为了减少测量中检测系统的影响,光通过在分析仪直后的去偏光散布仪。
2. Ceramic Gas Diffusor Fit Series
二氧化碳气保焊配件系列
3. PIV Measurement of Unsteady Flow within Blade Diffusor
叶片扩压器内部非定常流动的PIV测量
4. porous diffusor
多孔扩散消声器
5. Stator parts: It mainly consists of suction stage, mid-stage, discharge stage and diffusor, they are strained through a lever and form a working chamber.
定子部分:主要由进水段、中段、出水段和导叶等组成,由穿杠将各段拉紧,构成工作室。
6. jet diffusor
射流扩散器
7. micropole diffusor
小孔消声器
8. wide angle diffusor
广角度散布器
9. diffusor entry
扩散器入口
10. exhaust gas diffusor
排气扩散器
11. In this paper, it is combined that designing principle of diffusor and controlling noise theory of muffler.
本文把扩散器的设计原理与消声器的降噪理论相结合,并在此基础上进行扩散型消声器理论分析和实验研究。
12. The main parts of pump are suction-stage, middle-stage, discharge-stage, bearing support, motor support, impeller, diffusor, shaft, shaft bearing, shaft sleeve, balance kettle, balance sleeve etc.
泵主要由进水段、中段、出水段、轴承支架、电机支架、叶轮、导叶、轴、轴承、轴套、平衡鼓、平衡套等零件构成。
13. Proportional Solidification Technique of Gray Cast Iron Diffusor
灰铸铁扩压器均衡凝固工艺
14. Fabrication Process of Exhaust Gas Diffusor in Gas Turbine
燃气轮机排气扩散器的制造工艺探索
15. Theoretical and experimental investigation of noise in the vaned diffusor of centrifugal compressor
离心压缩机叶片扩压器噪声的理论和实验研究
16. The suction-stage, middle-stage, discharge-stage, diffusor and bearing support forms a working chamber and shaft, impeller, balance kettle and shaft sleeve are pump rotor parts.
进水段、中段、出水段、导叶、轴承支架形成工作室,轴、叶轮、平衡鼓和轴套组成转子部件。